The Rasor SW100, bench cutter model, is used in order to cut strong fabrics. By cutting with the blade and the counterblade always in contact and thanks to the steel upper quality of the blade supplied, SW100 cutter guarantees the clear separation without fraying of the two borders of the cut material. The fixture is extremely versatile, light and precise in the cutting operation. Thanks to the use of a sliding bearing base and an effective cutting system with a poligonal blade, it is possible to use the bench cutter to cut curved profiles not only in the textile and tannage sector, but also in several industrial sectors such as to cut polymers, thermoacoustic insulator, padding, neoprene, filters, synthetic and similar fabrics, moquette and internal parts of cars and ships.
The blade diameter (100mm) and the small weight (3Kg) makes this bench cutter the ideal fixture of cuts with small radius of curvature and with a thickness of up to 3.5cm. The wide sliding bearing base allows the operator to slide the cutter on the table without effort.
A sharpener assembled on the cutter heads allows whetting the blade at any moment without disassembling it. After carrying out this operation, it is possible to start cutting again.

The maximum sound pressure level emitted is approximately 60 dB (A). Airborne noise was detected in compliance with EN ISO 15744:2008. The noise levels emitted by the device at various detection distances (with no soundwave filtration system) vary by a few db (A).